Home > Forums > FLUENT

Initialising 3D model from 2D results?

Mark Forums Read

Reply

July 4, 2006, 08:58	Initialising 3D model from 2D results?	#1
Dan Guest Posts: n/a	Is it possible to initialise a 3D problem from 2D axisymmetric results? Thanks for any advice in advance.

Reply

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Wrong calculation of nut in the kOmegaSST turbulence model	FelixL	OpenFOAM Bugs	27	March 27, 2012 09:02
Atomization and Breakup model	xck1986	OpenFOAM	1	October 11, 2011 19:27
about Subgrid-scale model	impecca	OpenFOAM Running, Solving & CFD	2	September 12, 2010 13:47
OpenFOAM 13 Intel quadcore parallel results	msrinath80	OpenFOAM Running, Solving & CFD	13	February 5, 2008 05:26
standard k-eps model results?	cfd	Main CFD Forum	1	March 29, 2005 17:19

All times are GMT -4. The time now is 11:59.