|
[Sponsors] |
July 25, 2006, 01:14 |
Decoding Error Messages in Gambit
|
#1 |
Guest
Posts: n/a
|
While trying to clean-up and mesh a geometry, follwoing messages repeatedly appeared: (1) ERROR: SIGSEGV (Segmentation violation) while meshing v_face.33 (2)TGlig received signal SIGFPE (arithmetic exception) error: Traingle surface mesh of face v_face.33 failed (3) Cannot operate on face v_face.55 with associated real geometry (even though the validity check result says "0 out of 18 faces failed teh validity check)
Any information of these error message which will guide me to complete the meshing would be highly appreaciated. Thanks a lot in advance, Amod |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Gambit Startup Window | Jay Shim | FLUENT | 2 | February 12, 2015 14:05 |
Gambit help: Cube inside cube | Jack Martinez | FLUENT | 13 | August 11, 2010 06:29 |
Gambit 2.3.16, Xming or Exceed...HELP! | bambam3417 | FLUENT | 10 | May 7, 2010 12:39 |
Gambit -dev X11 doesn't work | Ervin Amet | FLUENT | 0 | October 28, 2007 08:33 |
3-D Mesh Check in Gambit..... | SHR | FLUENT | 4 | March 25, 2003 03:10 |