|July 26, 2006, 10:51||
journal file command for writing mass flow rate
I need the command you will use for writing the mass flow rate at a specified plane using a journal file.I am able to do it manually using Solve>Monitors>Surface ....
But i want to be able to do it using a journal file. For writing pressure on a surface located at a plane x=-146, i use the following lines of command in a journal file:
/solve/monitors/surface/set-monitor monp-01 pressure plane-x=-146
n n y /.auto/rz+cluster+w0/work/jw656314/RANS/urans_edm/plane_data/monp-plane-x=-146.data y "Area-Weighted Average"
I want similar lines of command for writing the mass flow rate at a surface. Specifically, i want to record the mass flow rate a the air inlet and the fuel inlet.
Any suggestions will be appreciated.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Mass flow rate through each cell||Babakjingo||Main CFD Forum||0||August 21, 2011 03:18|
|Mass flow rate||sepidecent||CFX||0||August 9, 2011 00:15|
|Version 15 on Mac OS X||gschaider||OpenFOAM Installation||120||December 2, 2009 11:23|
|Compiling gmshFoam with OpenFOAM-1.5||BlGene||Open Source Meshers: Gmsh, Netgen, CGNS, ...||10||August 6, 2009 04:26|
|Mass flow rate||Neser||CFX||4||February 14, 2004 01:27|