CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   FLUENT (http://www.cfd-online.com/Forums/fluent/)
-   -   Unwanted Wall Boundaries for 3D geometries (http://www.cfd-online.com/Forums/fluent/41856-unwanted-wall-boundaries-3d-geometries.html)

Cappy July 27, 2006 00:41

Unwanted Wall Boundaries for 3D geometries
 
When I create a 3D geometry in Gambit and then display the grid Fluent, a wall boundary usually appears that I did not create in Gambit. It will often be named "wall" and it consists of interior faces. I cannot figure out how to delete these walls in Fluent or how to change them to a boundary type that does not impede flow.

Gernot July 27, 2006 01:39

Re: Unwanted Wall Boundaries for 3D geometries
 
Sounds like a mistake made in gambit. You should have a look if the two volumes where the wall appears are conected to each other. hope that helps.



All times are GMT -4. The time now is 23:58.