CFD Online Discussion Forums

CFD Online Discussion Forums (
-   FLUENT (
-   -   Using soloution results for defining BC. (

Asghari August 17, 2006 03:54

Using soloution results for defining BC.
Hi all;

I am simulating flow within a plate heat exchanger . For this purpose , initially , i computed temperature distribution on plate using the fluent software(kind of plates is stainless steel and two dimensional). Now, i want to consider this plate as boundary for simulation of flow passing on it(3 dimenensional) . Is there a method that i export the temperature distribution information of plate to this boundary(mesh sizing for these two cases is'nt same and considered boundary for flow simulation is the part of original plate)?

Thanks in advance.

Mehdi Asghari

All times are GMT -4. The time now is 17:30.