Creating iso-surface with text commands

August 21, 2006, 04:40

Hi !

I would lique to create an iso-surface grid/y-coordinate using the text commands (in a journal). I wrote :

grid/iso-surface/y-coordiinate

* fluent asks me "from surface(1) [()]" ----> my answer: "()" ----> and fluent's answer: "#f"

* from zone(1) [()] ----> () ----->()

* iso-value(1) (m/s) ...

How can I have a y-coordinate in "m/s" ??? How can I do ???

Thank you very much !!

cyril

August 23, 2006, 11:38

Hello,

> grid/iso-surface/y-coordiinate

I believe, the above error in the spelling is not present in the journal file. Can you include the journal and transcript of the session? I have used the text-command to create iso-surfaces without any problem.

August 21, 2006, 04:40	Creating iso-surface with text commands	#1
Cyril Guest Posts: n/a	Hi ! I would lique to create an iso-surface grid/y-coordinate using the text commands (in a journal). I wrote : grid/iso-surface/y-coordiinate * fluent asks me "from surface(1) [()]" ----> my answer: "()" ----> and fluent's answer: "#f" * from zone(1) [()] ----> () ----->() * iso-value(1) (m/s) ... How can I have a y-coordinate in "m/s" ??? How can I do ??? Thank you very much !! cyril

August 23, 2006, 11:38	Re: Creating iso-surface with text commands	#2
Raj Kiran Grandhi Guest Posts: n/a	Hello, > grid/iso-surface/y-coordiinate I believe, the above error in the spelling is not present in the journal file. Can you include the journal and transcript of the session? I have used the text-command to create iso-surfaces without any problem.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Using text commands in FLUENT	shankara.2	FLUENT	2	July 20, 2009 14:18
Creating a Free Surface	Alex Reid	FLUENT	1	February 24, 2004 18:40
creating volume from a surface file for CFD	Amir	Main CFD Forum	0	December 24, 2002 02:08
Creating lines for surface integrals	Ale	FLUENT	2	October 16, 2002 15:35
CFX4.3 -build analysis form	Chie Min	CFX	5	July 12, 2001 23:19