CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   FLUENT (http://www.cfd-online.com/Forums/fluent/)
-   -   gambit: generate mesh from premeshed surfaces (http://www.cfd-online.com/Forums/fluent/42092-gambit-generate-mesh-premeshed-surfaces.html)

Ralf Schmidt August 22, 2006 10:43

gambit: generate mesh from premeshed surfaces
 
Hi!

I have a brick volume, that is premeshed on its 6 surfaces. On the 4 shell surfaces (the sides), the mesh has quad elements, the two opposite other surfaces (top and bottom) are meshed with tri elements (the same pattern).

Now, I want gambit to extent the tri elements from the top/bottom surface, forming in the volume wedge elements. The wedge elements should be build with help of the quad elements on the 4 sides.

This is like the copper scheme works, but I what it mannually.

How to to that???

Ralf

Gernot August 23, 2006 00:19

Re: gambit: generate mesh from premeshed surfaces
 
I think the problem is that the tri mesh is not the same on both sides ( even when you set the same parameters ). mesh just one side and cooper it - should be no problem if you have map on the side faces.

sam August 23, 2006 06:43

Re: gambit: generate mesh from premeshed surfaces
 
yes Gernot is right


All times are GMT -4. The time now is 06:47.