Error: pressure-far-field zone 1 has two adjacent
 

Hi all ! I've just exported a mesh from gambit to fluent, and the grid check says i've got an "Error: pressure-far-field zone 1 has two adjacent cell zones." Does smbd knows the meaning of this ???

I'll be very thanksfull if somebody could help me very quick ;-) !

Many thanks !!

Kiril

Re: Error: pressure-far-field zone 1 has two adjac
 

Probably it´s not a outside boundary? Perhaps it´s in the middle of the mesh (for that reason "has 2 adj cell zones")? Make sure it only has mesh on one side of the boundary.

Hope this helps!

Regards

Re: Error: pressure-far-field zone 1 has two adjac
 

Yep !

In fact, I've added a face after having set the boundaries... and all the side of this face were outside the boundaries...

Thanks !

P.S : Plzz tell me if I was clear enough... I'm trying to improve my english... any remark is welcome !!

Re: Error: pressure-far-field zone 1 has two adjac
 

I´m from Argentina so I´m working with my english too.. hehe, but I could understand you very well.

Take care.

Re: Error: pressure-far-field zone 1 has two adjac
 

I'm from France... I'll be studying in England next year (starting in 2 weeks!)

Thanks !

Bybye