Gambit does not copy volume connectivity

September 5, 2006, 09:50

I have two volumes which share a common face. When I copy the two volumes together to another location, each is copied separately and there is no longer a common face for the two copied volumes.

Is there a workaround for this?

September 5, 2006, 18:54

HI,

How did you create the first part. i presume you must have create a block and split that using a surface.

when you copy that they are two volumes with two individual faces.

Recreate the volume in the new location using surfaces.

Regards

Rajit

September 5, 2006, 09:50	Gambit does not copy volume connectivity	#1
smillerhh Guest Posts: n/a	I have two volumes which share a common face. When I copy the two volumes together to another location, each is copied separately and there is no longer a common face for the two copied volumes. Is there a workaround for this?

September 5, 2006, 18:54	Re: Gambit does not copy volume connectivity	#2
Rajit Guest Posts: n/a	HI, How did you create the first part. i presume you must have create a block and split that using a surface. when you copy that they are two volumes with two individual faces. Recreate the volume in the new location using surfaces. Regards Rajit

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
channelFoam for a 3D pipe	AlmostSurelyRob	OpenFOAM	3	June 24, 2011 13:06
[blockMesh] BlockMesh FOAM warning	gaottino	OpenFOAM Meshing & Mesh Conversion	7	July 19, 2010 14:11
Gambit: Volume Meshing	fluentnoob	ANSYS Meshing & Geometry	4	May 20, 2009 05:21
Connectivity data in GAMBIT	Rajveer Kaur	FLUENT	3	December 14, 2007 22:09
[blockMesh] Axisymmetrical mesh	Rasmus Gjesing (Gjesing)	OpenFOAM Meshing & Mesh Conversion	10	April 2, 2007 14:00