Home > Forums > FLUENT

display / report porous zone values

Mark Forums Read

Reply

September 7, 2006, 03:40	display / report porous zone values	#1
Ralf Schmidt Guest Posts: n/a	Hi! I want to write an UDF, that can define the values of a porous zone (porousity and inertial resistance). Now, to check, if the values are defined right, I want to display/report them... But how to do that???? Any idea is highly apreciated!! Ralf

Reply

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Porous Zone coordinate system	Rapha	OpenFOAM	2	September 30, 2011 04:21
Problem in running ICEM grid in Openfoam	Tarak	OpenFOAM	6	September 9, 2011 17:51
porousSimpleFoam: oscillating velocity in the porous zone	Se9a	OpenFOAM	2	February 10, 2011 07:44
Heated porous zone	Norris	FLUENT	0	April 1, 2008 12:07
Sliding mesh error	Karl Kevala	FLUENT	4	February 21, 2001 15:52

All times are GMT -4. The time now is 21:00.