|September 7, 2006, 16:58||
plotting in fluent
I defined 4 points in my problem and then i iterate for solution. i canot plot wht i want using monitors as it plots only against time or iterations. I want to plot a graph of temperature vs R(my R is 4 points that i have defined).I want to plot this for different times like for t=0 then after t=90 and so on in same plot window. I was trying to use XY plot but that gives me the final temp at these points after like 90 sec and then after running for 180 sec again if i plot it gives me final temp at these points after 180 sec and that too in a different window.
i want that my graph shld give at r=r1; t=0-----T=T1 then at r=r2; t=0-----T=T2
at r=r3; t=0-----T=T3
Also it shlg give at r=r1;t=90------T=T4and so on.
Can anyone help me with this?
Thanks in Avance.
|Thread||Thread Starter||Forum||Replies||Last Post|
|How to open Icem mesh in Ansys Fluent?||emmkell||FLUENT||26||June 9, 2015 15:38|
|Stopping a Fluent batch job AND saving the data! Possible?||Volker Pawlik||FLUENT||7||May 22, 2014 22:30|
|Two questions on Fluent UDF||Steven||Fluent UDF and Scheme Programming||4||September 20, 2013 16:30|
|Fluent 6.3 32bit vs Fluent 12.0 64bit||ibex7||FLUENT||7||April 18, 2011 02:44|
|Advanced Turbulence Modeling in Fluent, Realizable k-epsilon Model||Jonas Larsson||FLUENT||5||March 13, 2000 04:27|