 |
 |
 |
|
|
|
[Sponsors] | ||||
September 11, 2006, 11:40
|
Almost simple heat diffusion
|
#1 |
|
Guest
Posts: n/a
|
Hi, I'm trying to work out some heat diffusion (steady) problem with materials that differ by 5 orders of magnitude in heat conductivity coef. and are in contact with each other. Only double precision worked the overall heat ballance out. But it was very, very slow for only 150k tetra mesh (3D). Can somebody suggest something to speed it up. Thank you.
|
|
|
||
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Heat Flux at wall in a conjugate heat transfer problem | Chander | CFX | 2 | July 9, 2011 22:22 |
| Convective / Conductive Heat Transfer in Hypersonic flows | enigma | Main CFD Forum | 2 | November 1, 2009 22:53 |
| mass flow in is not equal to mass flow out | saii | CFX | 2 | September 18, 2009 08:07 |
| Problem of heat balance in Coal Boiler simulation | DG | FLUENT | 9 | December 25, 2008 20:57 |
| Simple heat conduction through a plate | vasu | OpenFOAM Running, Solving & CFD | 0 | May 18, 2006 03:01 |
Linear Mode
