|
[Sponsors] |
September 29, 2006, 03:54 |
Gambit: Face from wireframe problem
|
#1 |
Guest
Posts: n/a
|
When trying to create a face from wireframe GAMBIT replies "Attempting to create a face using ACIS Advanced Covering" and hangs up. Thanks for suggestions as to how to resolve this issue.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
area does not match neighbour by ... % -- possible face ordering problem | St.Pacholak | OpenFOAM | 10 | February 7, 2024 22:50 |
Fluent 6.3 / Gambit 2.3.16 / Exceed 11 problem on Win7 | pdilly | FLUENT | 23 | April 2, 2016 13:10 |
[GAMBIT] Problem with "link face mesh" | Naplich | ANSYS Meshing & Geometry | 6 | June 21, 2011 14:11 |
problem importing mesh into gambit | tsm554 | FLUENT | 7 | December 3, 2010 23:15 |
Problem starting Gambit | ViHAR MALViYA | FLUENT | 0 | November 10, 2006 11:26 |