In my caculation,it apprears the following information again and again:turbulent viscosity limited to viscosity ratio of 1.000000e+005 in 262718 cells.

And certainly it can't reach convergence even after 600 iterations.What's going wrong with it?

Hello,

I would recommend you to check whether you have scaled the grid properly when you first read the mesh into Fluent Solver.

Neelima

Thanks for your help.

I am sure I have scaled the grid properly,but the problem still exits.I don't know what to do next.

initiate the calculation with very low value to k, (default init is 0.1), I usually use 0.0001. In most cases this would solve the problem.

as i guess this is problem due to ill posed boundary condition. are u sure abt ur BC?

check the following 1) this comes mailny due to mesh quality issue (skewness and aspect ratio) 2) it may go off after few thousand iteration 3)

let me know for any quary sachcool80@gmail.com

hello ,

increase the limit values in the solve menu ... this will solve the problem .. i used to do this when such a situation comes

mahendran

increase the limit values in the solve - controls - limits ... this will solve the problem .. i used to do this when such a situation comes

mahendran