|
[Sponsors] |
October 12, 2006, 04:10 |
movin wall
|
#1 |
Guest
Posts: n/a
|
Hello I am using moving wall boundary condition. Problem is I have four wall of a plate when i give velocity in the Y direction to the walls. It shows the velocity y component at vertical walls but did not show any velocity at the other two walls. Althouhg it shows the velocity magnitude in all the walls. It is strange that if it shows the velocity magnitude it should also shows the y component of the velocity as their is zero velocity in the x direction. IWhat i am doing wrong is it my interpretion or i am doing some bug. Thanks in advance Rashad
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Commercial meshers] Fluent3DMeshToFoam | simvun | OpenFOAM Meshing & Mesh Conversion | 50 | January 19, 2020 15:33 |
Natural convection in a closed domain STILL NEEDING help! | Yr0gErG | FLUENT | 4 | December 2, 2019 00:04 |
Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |
Errors running allwmake in OpenFOAM141dev with WM_COMPILE_OPTION%3ddebug | unoder | OpenFOAM Installation | 11 | January 30, 2008 20:30 |
Multicomponent fluid | Andrea | CFX | 2 | October 11, 2004 05:12 |