Help: Basic steps to get dynamic mesh working
Hello,
I need to simulate a flow past a oscillating cylinder. I tried to read the manual regarding dynamic mesh but it doesn't seem to help. Is there anywhere on the net where there's relevent tutorial on how to do it? Or can someone help or send me his/her case/data file? Thank you. |
Re: Help: Basic steps to get dynamic mesh working
whats the problem, if you are unable to dynamic mesh this should enable it:
(rpsetvar 'dynamic-mesh? #t) i have some docs please give me your email, i shall mail you as time permits |
Re: Help: Basic steps to get dynamic mesh working
thank you very much. my email is quarkz@126.com.
|
Re: Help: Basic steps to get dynamic mesh working
i sent you few docs, please check your bulk folder also.
|
Re: Help: Basic steps to get dynamic mesh working
Hello, I'm facing the same problem. Can somebody help me too ?
|
All times are GMT -4. The time now is 06:07. |