|
[Sponsors] |
October 17, 2006, 23:45 |
How to setup an airplane propeller?
|
#1 |
Guest
Posts: n/a
|
Hi folks, I´m preparing a simulation for the college of a twin engine plane (I´ll calculate only one half). I´m wondering about the propeller, wich model should I use? Rotating wall boundary condition, sliding mesh or what?.
Thanks in advance! |
|
October 18, 2006, 01:59 |
Re: How to setup an airplane propeller?
|
#2 |
Guest
Posts: n/a
|
Hi,
Rotating reference frame. Go through this model. Regards Ryan |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Propeller calculation | toil | CFX | 15 | May 22, 2017 04:06 |
[ICEM] Hexa mesh, curve mesh setup, bunching law | Anorky | ANSYS Meshing & Geometry | 4 | November 12, 2014 00:27 |
Propeller airplane | satriani | STAR-CCM+ | 2 | May 23, 2011 03:12 |
Modelling a propeller | tomg | STAR-CCM+ | 4 | April 28, 2011 17:22 |
Modelling airplane fuselage with propeller | thepassenger | FLUENT | 1 | November 8, 2010 22:19 |