|
[Sponsors] |
October 18, 2006, 17:09 |
Gambit
|
#1 |
Guest
Posts: n/a
|
Hi I have to design a combustion chamber in Gambit and Fluent. The problem is with meshing. The geometry is an annulus with two holes on the top surface for inlet. Can you give me a general idea about how to go about the meshing ? The mixture of air and fuel is inside the hollow annulus and I want to model it. So should I keep the annulus solid or do I model it as a hollow region ?
Please reply Thanks a lot baan |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ANSYS Meshing] Migrating from GAMBIT to ANSYS Meshing | David-CFD | ANSYS Meshing & Geometry | 1 | April 1, 2011 05:22 |
Gambit help: Cube inside cube | Jack Martinez | FLUENT | 13 | August 11, 2010 06:29 |
Gambit 2.3.16, Xming or Exceed...HELP! | bambam3417 | FLUENT | 10 | May 7, 2010 12:39 |
Gambit -dev X11 doesn't work | Ervin Amet | FLUENT | 0 | October 28, 2007 08:33 |
3-D Mesh Check in Gambit..... | SHR | FLUENT | 4 | March 25, 2003 03:10 |