|
[Sponsors] |
Gambit Expert On mehing volume with boundary layer |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 18, 2006, 18:35 |
Gambit Expert On mehing volume with boundary layer
|
#1 |
Guest
Posts: n/a
|
Hi evrybody, I have a volume, it had in one face boundary layer with size (2-1), when i treid to mesh the volume with TGrid , i had a error. The error message is "Initialization failed perturb boundary nodes and try again"
Any suggestion? Thanks in advance! Falah |
|
October 18, 2006, 23:01 |
Re: Gambit Expert On mehing volume with boundary l
|
#2 |
Guest
Posts: n/a
|
hey during the meshing the zone in which you are expecting the tet mesh (part of domain remaining after bl) should be defined as seperate and active zone. then mesh the remaining after capturing the domain with the outer boundary layer wall and the other walls If you dont rezone the mesh will try to purturb into the bl and error TG reports the error
mail me if it work sachcool80@gmail.com |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[GAMBIT] 3D boundary layer and meshing problem in GAMBIT 2.4.6 | prashanthreddyh | ANSYS Meshing & Geometry | 1 | December 20, 2011 00:35 |
Not able to mesh a helix with boundary layer using gambit | rohitjvbibin | Main CFD Forum | 0 | March 5, 2011 11:28 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |
Errors in Gambit for boundary layer mesh | Mike Spears | FLUENT | 0 | June 23, 2005 11:34 |
errors | Fahad | Main CFD Forum | 0 | March 23, 2004 13:20 |