CFD Online Discussion Forums

CFD Online Discussion Forums (
-   FLUENT (
-   -   Gambit (

baan October 18, 2006 17:09

Hi I have to design a combustion chamber in Gambit and Fluent. The problem is with meshing. The geometry is an annulus with two holes on the top surface for inlet. Can you give me a general idea about how to go about the meshing ? The mixture of air and fuel is inside the hollow annulus and I want to model it. So should I keep the annulus solid or do I model it as a hollow region ?

Please reply Thanks a lot baan

All times are GMT -4. The time now is 06:18.