CFD Online Logo CFD Online URL
Home > Forums > FLUENT

Gambit Expert On mehing volume with boundary layer

Register Blogs Members List Search Today's Posts Mark Forums Read

LinkBack Thread Tools Display Modes
Old   October 18, 2006, 18:35
Default Gambit Expert On mehing volume with boundary layer
Posts: n/a
Hi evrybody, I have a volume, it had in one face boundary layer with size (2-1), when i treid to mesh the volume with TGrid , i had a error. The error message is "Initialization failed perturb boundary nodes and try again"

Any suggestion? Thanks in advance! Falah
  Reply With Quote

Old   October 18, 2006, 23:01
Default Re: Gambit Expert On mehing volume with boundary l
Posts: n/a
hey during the meshing the zone in which you are expecting the tet mesh (part of domain remaining after bl) should be defined as seperate and active zone. then mesh the remaining after capturing the domain with the outer boundary layer wall and the other walls If you dont rezone the mesh will try to purturb into the bl and error TG reports the error

mail me if it work
  Reply With Quote


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

Similar Threads
Thread Thread Starter Forum Replies Last Post
[GAMBIT] 3D boundary layer and meshing problem in GAMBIT 2.4.6 prashanthreddyh ANSYS Meshing & Geometry 1 December 20, 2011 01:35
Not able to mesh a helix with boundary layer using gambit rohitjvbibin Main CFD Forum 0 March 5, 2011 12:28
Axisymmetrical mesh Rasmus Gjesing (Gjesing) OpenFOAM Native Meshers: blockMesh 10 April 2, 2007 14:00
Errors in Gambit for boundary layer mesh Mike Spears FLUENT 0 June 23, 2005 11:34
errors Fahad Main CFD Forum 0 March 23, 2004 14:20

All times are GMT -4. The time now is 13:21.