|
[Sponsors] |
November 4, 2006, 07:01 |
moving block in a domanin
|
#1 |
Guest
Posts: n/a
|
Hi I am encountering a problem while solving a case in which a car is moving on the ground. To simplify it, lets consider a 2-D box moving in a domain. I am using the dynamic meshes technique (dynamic layering) to move the car and have written a UDF for the motion. Now the problem iI am facing is that the side edges are not having the velocity of the top surface of the box (car). Thus what I currently have is like a solidification problem for the top surface and a melting for the bottom with 0 velocities at the side walls. To solve this tried to give those walls a velocity by BC's panel as well as UDF but I am unsuccessfull. I have also tried the remeshing technique alone but its not working for me. Kindly let me know if you have solution for this above issue
Thanks, Ankit |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] jagged, ragged edges... | ziemowitzima | OpenFOAM Meshing & Mesh Conversion | 138 | July 23, 2012 23:41 |
[ICEM] Moving Block Nodes In View Plane | tav98f | ANSYS Meshing & Geometry | 5 | August 13, 2011 12:58 |
Moving mesh in Fluent | fivos | FLUENT | 0 | April 2, 2010 09:45 |
[Commercial meshers] Icem Mesh to Foam | jphandrigan | OpenFOAM Meshing & Mesh Conversion | 4 | March 9, 2010 02:58 |
blockMesh: block with 6 vertexes | dani | OpenFOAM | 3 | June 25, 2009 13:13 |