CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > FLUENT

Filling air-filled microtube with Water using VOF

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Display Modes
Old   November 6, 2006, 12:17
Default Filling air-filled microtube with Water using VOF
  #1
Ybes
Guest
 
Posts: n/a
Hello everyone,

i am trying to fill a small 2-D tube/chamber with inlet width of 1.5 mm, initially filled with air, with water. Inlet Velocity is 0.0005 m/sec.. Outlet is set as Pressure-Outlet. I am using the VOF-model and spalart-Allmaras or Low-Re-k-e-model, as Re<200. Wall-adhesion is enabled. To allow higher sub-time steps i coarsened the grid, so that a time-step of 1e-4 is (larger time-step is however risky) possible. This still takes a lot of computational time, but i can't find a better way to speed up the simulation. i set the operating pressure to 101325 and outlet pressure to 100, i am not sure if these pressure values are correct. Can anyone help me please?
  Reply With Quote

Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Modelling free falling water into a air filled duct? sandmike_83 CFX 4 August 24, 2010 03:27
air bubble is disappear increasing time using vof xujjun CFX 9 June 9, 2009 07:59
VOF for water drop in air Talia FLUENT 0 September 3, 2006 05:57
Help!!!problems in air jet into water bath kim FLUENT 4 June 9, 2003 07:04
Air and Water VOF model, Error?? boris FLUENT 5 July 19, 2002 03:08


All times are GMT -4. The time now is 07:04.