 |
 |
 |
|
|
|
[Sponsors] | ||||
November 15, 2006, 04:31
|
How to stop iteration with TUI?
|
#1 |
|
Guest
Posts: n/a
|
Hello,everyone!
I want to stop the iteration with TUI,and save the advanced results.And I write a journal file to do it,can anybody helps me out? Thanks a lot! sophie |
|
|
||
|
November 15, 2006, 04:35
|
Re: How to stop iteration with TUI?
|
#2 |
|
Guest
Posts: n/a
|
Ctrl + C
|
|
|
|
||
|
November 15, 2006, 04:38
|
Re: How to stop iteration with TUI?
|
#3 |
|
Guest
Posts: n/a
|
oops sorry, I have not read teh entire message. there is a workaround: check pointing! are you on windows or unix?
|
|
|
|
||
|
November 15, 2006, 12:39
|
Re: How to stop iteration with TUI?
|
#4 |
|
Guest
Posts: n/a
|
In Linux .... touch /tmp/exit-fluent
|
|
|
|
||
|
November 23, 2006, 05:18
|
Re: How to stop iteration with TUI?
|
#5 |
|
Guest
Posts: n/a
|
Sorry to re your message for a long time!
I'm on WINDOWS. If you have solution,please let me know, Thanks a lot! sophie |
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how to increase "Newton Pressure Iteration Limit" | kus | CFX | 9 | April 21, 2013 01:54 |
| [snappyHexMesh] snappyHexMesh aborting | Tobi | OpenFOAM Meshing & Mesh Conversion | 0 | November 10, 2010 03:23 |
| Stop iteration and continuation of the process | martapajon | OpenFOAM Running, Solving & CFD | 3 | November 5, 2007 15:06 |
| Parallel runs slower with MTU=9000 than MTU=1500 | Javier Larrondo | FLUENT | 0 | October 28, 2007 22:30 |
| Heat exchanger problem | chiseung | FLUENT | 16 | October 20, 2001 04:36 |
1Likes
Linear Mode
