|
[Sponsors] |
November 15, 2006, 12:03 |
Impeller mesh size (Unstructered)
|
#1 |
Guest
Posts: n/a
|
Hai all,
Can anyone please recommend me to know the rough size of the mesh required to model a frozen impeller(alone) with 11 vanes having 1020mm outer diameter. Thanks in advance Abdul |
|
November 16, 2006, 04:21 |
Re: Impeller mesh size (Unstructered)
|
#2 |
Guest
Posts: n/a
|
hai
did you used turbo tool or not, if not pls try turbo tool,for proper meshing model must be fine with out any distortions,if u used turbo tool check with changing the inlet and outlet virtual vertices |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] SnappyHexMesh for internal Flow | vishwa | OpenFOAM Meshing & Mesh Conversion | 24 | June 27, 2016 08:54 |
Superlinear speedup in OpenFOAM 13 | msrinath80 | OpenFOAM Running, Solving & CFD | 18 | March 3, 2015 05:36 |
unstructure mesh size control near to wall using gambit | lalit kumar | FLUENT | 4 | July 6, 2010 15:13 |
Gambit Unstructed (Tet) Mesh - size control | newbie | FLUENT | 3 | August 26, 2008 11:38 |
Phase locked average in run time | panara | OpenFOAM | 2 | February 20, 2008 14:37 |