Periodic Boundaries in GAMBIT!!

November 20, 2006, 10:51

Hi,

Can anyone help me about how to apply periodic boundaries in GAMBIT. My test case is a 3D Cylinder with periodic boundaries on the +z and -z. The cylinder is divided into 4 zones for convenience of meshing the wake region. My question is do we have to apply the periodic boundaries in pairs (4sets) as i have 4 zones or can i select all the faces and treat it as a single set for the periodic boundaries.

Please do help!! Thanks,swetha

November 26, 2006, 22:02

Do you make the link mesh before meshing ???

November 20, 2006, 10:51	Periodic Boundaries in GAMBIT!!	#1
swetha Guest Posts: n/a	Hi, Can anyone help me about how to apply periodic boundaries in GAMBIT. My test case is a 3D Cylinder with periodic boundaries on the +z and -z. The cylinder is divided into 4 zones for convenience of meshing the wake region. My question is do we have to apply the periodic boundaries in pairs (4sets) as i have 4 zones or can i select all the faces and treat it as a single set for the periodic boundaries. Please do help!! Thanks,swetha

November 26, 2006, 22:02	Re	#2
Sano Guest Posts: n/a	Do you make the link mesh before meshing ???

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
periodic boundaries	Mary	FLUENT	7	May 12, 2013 08:16
Why can't I make the boundaries periodic?	Alina	FLUENT	5	April 12, 2012 14:06
[ICEM] Periodic boundaries in two directions	jphastings	ANSYS	2	November 5, 2011 19:07
periodic boundaries - flow through a net	PK	FLUENT	0	July 12, 2007 11:58
Gambit periodic boundaries vs TGrid	AnnaG	FLUENT	0	June 20, 2002 16:16