|
[Sponsors] |
December 26, 2006, 04:41 |
Meshing Error
|
#1 |
Guest
Posts: n/a
|
I encounterd an error where it says: Volume contains internal dangling face and so cannot be meshed with Map.
I tried to change the type of mesh used bt it still gives an error. Any idea what is a dangling face? |
|
December 29, 2006, 05:48 |
Re: Meshing Error
|
#2 |
Guest
Posts: n/a
|
go to fluent help, u can find the literature about dangling face. it also guides to handle or eliminate dangling faces
|
|
January 2, 2007, 02:14 |
Re: Meshing Error
|
#3 |
Guest
Posts: n/a
|
Hi sharon,
Dangling face is something which is not referenced by the volume to which it is attached. I beleive there is an extra face. Delete this face and try again. Regards Ryan |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh | gschaider | OpenFOAM Community Contributions | 300 | October 29, 2014 18:00 |
Compile problem | ivanyao | OpenFOAM Running, Solving & CFD | 1 | October 12, 2012 09:31 |
compile errors of boundary condition "expDirectionMixed" | liying02ts | OpenFOAM Bugs | 2 | February 1, 2010 20:11 |
Problems of Duns Codes! | Martin J | Main CFD Forum | 8 | August 14, 2003 23:19 |
error while compiling the USER Sub routine | CFD user | CFX | 3 | November 25, 2002 15:16 |