Isometric View?

January 14, 2007, 05:07

Hi there! After running simulations in FLUENT, is there any command which i can execute so that i can view my model in an isometric view?

Thanks!

January 16, 2007, 00:44

go to disply -grid,there select,you select out line in edge type.u will get isometric view in out line,

January 16, 2007, 08:48

There are pre-defined camera angles... Dislpay->Views... you'll see them there.

Good luck, Jason

January 16, 2007, 18:11

hi jason,

thanks for your reply.. i managed to see them there, i.e, 'display->views', but how do i actually see, for example, the contours of static temperature for my simulation?

best regards, linus

January 14, 2007, 05:07	Isometric View?	#1
linus chia Guest Posts: n/a	Hi there! After running simulations in FLUENT, is there any command which i can execute so that i can view my model in an isometric view? Thanks!

January 16, 2007, 00:44	Re: Isometric View?	#2
sudhakar Guest Posts: n/a	go to disply -grid,there select,you select out line in edge type.u will get isometric view in out line,

January 16, 2007, 08:48	Re: Isometric View?	#3
Jason Guest Posts: n/a	There are pre-defined camera angles... Dislpay->Views... you'll see them there. Good luck, Jason

January 16, 2007, 18:11	Re: Isometric View?	#4
linus Guest Posts: n/a	hi jason, thanks for your reply.. i managed to see them there, i.e, 'display->views', but how do i actually see, for example, the contours of static temperature for my simulation? best regards, linus

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
View particle trajectory in CFD View	xonix	Main CFD Forum	1	April 25, 2011 23:40
S2S radiation - view factor file error	Tolis	FLUENT	1	May 12, 2009 06:17
isometric view?	linus	FLUENT	1	February 14, 2007 02:06
Fluent - View Factor for s2s radiation	Markus	FLUENT	1	October 16, 2005 01:33
view rotation in provis	Anna (aka new-user)	Siemens	3	November 19, 2004 08:45