|
[Sponsors] |
January 24, 2007, 04:37 |
impeller
|
#1 |
Guest
Posts: n/a
|
Hi, i was wondering if anyone knows a udf that can be assigned to two impellers in motion. the impellers are both on the same shaft. the udf i am using is only allowing me the use of just one impeller (or sometimes the other!!). i am trying to fix the velocity profile on them.
|
|
January 24, 2007, 07:25 |
Re: impeller
|
#2 |
Guest
Posts: n/a
|
can you show me the schematic of your geometry and tell the motion you want to have? I will surely help you...
|
|
January 29, 2007, 02:53 |
Re: impeller
|
#3 |
Guest
Posts: n/a
|
thx for your rep. the tank is 11.5 by 10 m. the slurry level is upto 10.9m. there is a shaft of 0.2m at the middle, which consists of 2 impellers of 0.25m in width and each a total of 1ength of 1.4m.the distance bet the bottom impeller and the bottom of the tank is 3.5m. the distance bet the two impellers id 4.2m. i am trying to do a 2d simulation.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Eckardt Impeller (1980) test results. | Andrew de Wet | Main CFD Forum | 7 | July 8, 2017 02:57 |
Having a few problems in simulating a rotating impeller | ajinsan | CFX | 12 | February 4, 2016 16:10 |
Volute outlet flow into impeller inlet | Anthony_impeller | CFX | 4 | December 13, 2011 16:17 |
Simulation of an Axial Impeller | cnchilavert | CFX | 1 | October 15, 2011 02:01 |
tascflow - impeller volute interface | abaqus | CFX | 0 | August 21, 2003 13:06 |