|
[Sponsors] |
January 18, 2007, 09:37 |
how to assign fan boundary condition
|
#1 |
Guest
Posts: n/a
|
i having been trying to assign a face as fan , but i keep on getting an error that there is only one adjacent cell thread, how do i go about that i have stitch the faces
|
|
January 18, 2007, 13:49 |
Re: how to assign fan boundary condition
|
#2 |
Guest
Posts: n/a
|
Fan boundary conditions are usually applied to interior faces...where there are cells on both sides, I m not sure whether it is applicable to a face at boundary?
To get an interior face you have to split one volume in to two using a face with connected option turned on, Now you can mesh the model and define the common face of the two volumes as interior boundary. you can change this to fan in Fluent -sujith |
|
January 19, 2007, 03:33 |
how to mesh a bellmouth in a brick volume
|
#3 |
Guest
Posts: n/a
|
i am trying to mesh a test fan facility (BS408)standard A. i am finding it difficult to mesh the atmosphere, the bellmouth where the fan is situated and the settling chamber how do i go about the meshing, uniting and stitching the faces did not work
|
|
January 19, 2007, 03:34 |
how to mesh a bellmouth in a brick volume
|
#4 |
Guest
Posts: n/a
|
i am trying to mesh a test fan facility (BS408)standard A. i am finding it difficult to mesh the atmosphere, the bellmouth where the fan is situated and the settling chamber how do i go about the meshing.i have tried uniting and stitching the faces, but did not work.
|
|
January 21, 2007, 10:47 |
how to specify blade angle
|
#5 |
Guest
Posts: n/a
|
i want to know how to specify blade angle in a fan
|
|
January 31, 2007, 08:58 |
i want to understand the concept of unmatched boun
|
#6 |
Guest
Posts: n/a
|
i want to know the concept of unmatched boundary and how it is managed
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
mixed inflow/outflow downstream boundary condition question | peob | OpenFOAM Running, Solving & CFD | 3 | February 3, 2017 11:54 |
inlet velocity boundary condition | murali | CFX | 5 | August 3, 2012 09:56 |
boundary condition - fan | hari | FLUENT | 0 | October 9, 2007 04:14 |
Slip boundary condition what is inside | normunds | OpenFOAM Running, Solving & CFD | 2 | June 4, 2007 07:45 |
simple question about fan boundary condition | Jane | FLUENT | 0 | June 24, 2004 17:40 |