Home > Forums > Software User Forums > ANSYS > FLUENT

Simple Laser Drilling Setup

Mark Forums Read

Reply

Search this Thread

January 31, 2007, 00:02	Simple Laser Drilling Setup	#1
Jason Guest Posts: n/a	Has anyone here successfully used Gambit/Fluent to successfully model a laser drilling process? Im not even worried about modeling the material removal right now, but mainly applying a very high heat flux on a very small spot size, that is part of a larger workpiece and looking the temp. distribution throughout the material. Any help would be appreciated. Thanks in advance. -Jason

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Hexa mesh, curve mesh setup, bunching law	Anorky	ANSYS Meshing & Geometry	4	November 12, 2014 00:27
SIMPLE algorithm in 3D cylindrical coordinates	zouchu	Main CFD Forum	1	January 20, 2014 17:02
The correction on pressure equation of SIMPLE algorithm in MRFSimpleFOAM solver	renyun0511	OpenFOAM Running, Solving & CFD	0	November 10, 2010 01:47
Simulation of Laser Drilling in FLUENT	JB	FLUENT	0	November 20, 2006 00:12
PISO vs. SIMPLE	benedikt flurl	Main CFD Forum	2	April 14, 2005 06:54

All times are GMT -4. The time now is 01:25.