CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > ANSYS > FLUENT

Flash Tank Simulation

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   February 16, 2007, 02:21
Default Flash Tank Simulation
  #1
Hamid Nabati
Guest
 
Posts: n/a
I'm going to simulate a special flash tank using Fluent software as a part of my thesis. The flash tank is used in a process line in the Alumina factory. I would like to know whether it is possible fundamentally to use Fluent for this purpose or not? the complementary informatoions are as following: 1- The raw material entering the flash tank is bauxite slurry(a mixture of milled bauxite, lime and weak caustic liquor) 2- Inlet T and P are:270 C, 5.74 Mpa 3- Flash tank pressure :4.41 Mpa

  Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Resume Transient simulation HMR CFX 1 June 28, 2011 22:13
Roll Tank Simulation Sam CFX 14 February 15, 2009 21:21
Continuous vs interrupted simulation sega OpenFOAM Running, Solving & CFD 4 November 3, 2008 15:29
Pressure BCs for rasInterFoam tank fillingdraining problem kwardle OpenFOAM Running, Solving & CFD 8 September 17, 2008 15:37
simulation of a stirred tank hu CFX 0 February 17, 2001 08:23


All times are GMT -4. The time now is 02:46.