|
[Sponsors] |
February 16, 2007, 03:50 |
tip clearence in turbo tool
|
#1 |
Guest
Posts: n/a
|
hai friends i am doing a project with the turbo tool, when i am doing with tip clearene,0.65mm its coming the correct model, when i am trying to do with 0.5mm,the volume is creating in blade section also, some times coming the model exacctly,
can anyone suggest me how can i resolve this proublem |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Blade tip with tetra/prism method | vinc | ANSYS Meshing & Geometry | 0 | May 17, 2011 15:22 |
[ICEM] Structured Mesh 3D Wing Tip | Michiel | ANSYS Meshing & Geometry | 5 | October 21, 2010 08:39 |
Initialisation problem Turbo tool CFX-Post | Toralf | CFX | 0 | February 13, 2008 05:44 |
tip clearence in turbo tool | Sastry | FLUENT | 0 | February 16, 2007 03:46 |
Stator tip gap at hub in turbogrid /CFX post turbo | Adam | CFX | 1 | May 29, 2006 04:47 |