How to set two inlet boundary condition???Plz help
Hi all;
I have two inlet boundary condition, pressures and velocities in inlet have a specified value;For example : Pin1=10barg,Vin1=10m/s. Pin2=05barg,Vin2=05m/s. How to adjust fluent setting for this case? Should I use a UDF for this case? have you an example or a tutorial like as this case? Thanks in advance for any help. |
2 inlet
hello
i dont think we can apply two inlet conditions, atleast i have not used it. however if you get to know about it then tell me too |
All times are GMT -4. The time now is 20:57. |