|
[Sponsors] |
February 7, 2007, 23:29 |
boundary conditions
|
#1 |
Guest
Posts: n/a
|
can anyone plz help me......i defined one of my faces as interior in gambit but in in fluent it is showing as wall.....how can i solve this problem piyush
|
|
February 7, 2007, 23:32 |
Re: boundary conditions
|
#2 |
Guest
Posts: n/a
|
read help files regarding heat exchanger models
|
|
February 7, 2007, 23:45 |
Re: boundary conditions
|
#3 |
Guest
Posts: n/a
|
hiii actually m solving a heat exchanger problem......its a 1-2 pass heat exchanger......how can i make the flow to pass through the tubes....the tubes are not connected.....plz help me out..... thanx in advance......i hav gone thru the help files but m not getting anythin........plz help piyush
|
|
February 8, 2007, 04:05 |
Re: boundary conditions
|
#4 |
Guest
Posts: n/a
|
Hi piyush, i think i have the same problem with radiation. uv radiation born from a lamp in the air but doesn't pass throught a tube (made by teflon). How can i define the tube? as wall? interior?
|
|
February 8, 2007, 14:11 |
Re: boundary conditions
|
#5 |
Guest
Posts: n/a
|
two-side wall is needed to let the radiation or heat transfer to the wall. Ferdinando, see you e-mail.
|
|
February 20, 2007, 09:29 |
Re: boundary conditions
|
#6 |
Guest
Posts: n/a
|
make sure that all the surrounding subvolumes are meshed.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Impinging Jet Boundary Conditions | Anindya | Main CFD Forum | 25 | February 27, 2016 12:58 |
symmetry boundary conditions in cfx | lost.identity | CFX | 41 | May 22, 2013 07:21 |
OpenFOAM Variable Velocity Boundary Conditions | NickolasPl | OpenFOAM Programming & Development | 2 | May 19, 2011 05:37 |
[Netgen] boundary conditions and mesh exporting | vaina74 | OpenFOAM Meshing & Mesh Conversion | 2 | May 27, 2010 09:38 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |