|
[Sponsors] |
February 23, 2007, 00:11 |
Fuel Cell modeling
|
#1 |
Guest
Posts: n/a
|
Hi, everybody,
I am modeling PEMFC. Now I run in troubles and I expect I can get a favor from you. I use UDS to describe electron potential and proton potential but I do not know how to set boundary conditions for them. Firstly, I give my process for electron potential. In define_diffusivity I give the conductivities of catalyst layer and diffusion layer(electrode) and set conductivitities of membrane zero (the number is only for UDS_electron potential). Then I give the boundaries conditions: the interface between anode diffusion layer and channel is 0 and the interface between cathode diffusion layer and channel is 1V. However, the UDS can not be run. What's wrong with the idea? what need I do for the model? How do I deal with the UDS_electron potential and UDS_proton potential? Thank you very much! Braket |
|
February 23, 2007, 16:10 |
Re: Fuel Cell modeling
|
#2 |
Guest
Posts: n/a
|
fluent support has the most advanced expertise in porous media flow and fuel cell. you should contact the support
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
PEM fuel cell modeling | alimech | Main CFD Forum | 4 | April 18, 2020 13:15 |
Cells with t below lower limit | Purushothama | Siemens | 2 | May 31, 2010 21:58 |
PEM Fuel Cell Modeling with OpenFOAM | Berker | OpenFOAM | 1 | May 3, 2009 19:16 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |
Warning 097- | AB | Siemens | 6 | November 15, 2004 04:41 |