error message
Hi all,
After a few iteration, the message appear as below: temperature limited to 1.000000e+000 in 168 cells on zone 2 in domain 1 temperature limited to 5.000000e+003 in 2025 cells on zone 2 in domain 1 turbulent viscosity limited to viscosity ratio of 1.000000e+005 in 13344 cells Error: Floating point error: invalid number What all these mean? Thanks in advance rayy |
Re: error message
Please be a bit conservative while starting of your simulation.
Hope you unerstand. Good luck!! Regards Ronald |
Re: error message
hi ronald,
Actually I dont understand what u mean. Please explain.... thanks rayy |
Re: error message
Hi,
Ckeck the intial conditions you have specified makes sense. Then reduce the momentum and continuity residuals and try the simulation. This should work. If it dosent check the boundary conditions. Ta Regards Ronald |
All times are GMT -4. The time now is 14:36. |