|
[Sponsors] |
March 5, 2007, 09:25 |
Drawing fibre from furnace
|
#1 |
Guest
Posts: n/a
|
I model in Fidap drawing a fiber from a preform from a furnace - a 3-D problem in a cone with a hole - 2 free surfaces. When I change by any order material properties - such as viscosity, the velocity field doesn't change. Also when using spines - ENTITY(NAME="free",SURFACE,DEPTH=0,SPINE,STRAIGHT) the new shape of the cone doesn't depend on surface tension or additional pressure in the hole and the velocity field is as if there wasn't surface tension.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
What a Strange Drawing in GAMBIT... | teguhtf | ANSYS Meshing & Geometry | 3 | October 5, 2009 11:17 |
Furnace curtains | Marc | FLUENT | 0 | April 18, 2007 08:01 |
Furnace Combustion wall problem | Leigh | FLUENT | 2 | December 11, 2006 15:01 |
Inclination of the furnace | Clif | CFX | 1 | October 4, 2006 05:48 |
Furnace wall heat exchange | Andrea | FLUENT | 8 | November 11, 2005 03:37 |