3Dblade mesh

March 26, 2007, 14:43

Hi, I'm trying to mesh a flow passage over 3D blade domain. The blade is twisted and its cross-section changes with the heigth.The flow domain is small, inlet is placed one chord length upstream and outlet two chord lengths downstream the blade, the other boundaries are offsets of the blade surface and the flow has a 90deg turn. I created a mesh on of the blade surface and attached a b.l. mesh. So far I was not able to mesh the entire volume using the different schemes. Any suggestion? Should I divide the volume in blocks?

Thanks

March 28, 2007, 00:47

Yes.

Which software do you use, Gambit?

March 30, 2007, 17:20

yes, I'm using Gambit. Anyway, dividing the volume in blocks I was able to mesh it. Thank you.

March 26, 2007, 14:43	3Dblade mesh	#1
dan Guest Posts: n/a	Hi, I'm trying to mesh a flow passage over 3D blade domain. The blade is twisted and its cross-section changes with the heigth.The flow domain is small, inlet is placed one chord length upstream and outlet two chord lengths downstream the blade, the other boundaries are offsets of the blade surface and the flow has a 90deg turn. I created a mesh on of the blade surface and attached a b.l. mesh. So far I was not able to mesh the entire volume using the different schemes. Any suggestion? Should I divide the volume in blocks? Thanks

March 28, 2007, 00:47	Re: 3Dblade mesh	#2
aja Guest Posts: n/a	Yes. Which software do you use, Gambit?

March 30, 2007, 17:20	Re: 3Dblade mesh	#3
dan Guest Posts: n/a	yes, I'm using Gambit. Anyway, dividing the volume in blocks I was able to mesh it. Thank you.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] surface mesh merging problem	everest	ANSYS Meshing & Geometry	44	April 14, 2016 06:41
Converting Starccm+ mesh	Ladnam	OpenFOAM	0	September 14, 2011 06:30
Meshing aifoil in ICEM	student123a	ANSYS Meshing & Geometry	13	December 8, 2010 10:40
2d irregular grid	Remy	Main CFD Forum	1	December 22, 2008 04:49
basic of mesh refinement	arya	CFX	4	June 19, 2007 12:21