CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > FLUENT

how to model it

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Display Modes
Old   March 31, 2007, 05:35
Default how to model it
  #1
renuka
Guest
 
Posts: n/a
hi i am modeling a fluid flow through a pipe such that 1)a high presure gas flow into the tube for 2sec. at that time outlet is closed 2)then both outlet and inlet remain closed for 1sec, 3)then outlet get opened for another 2sec during this time inlet remain closed.

The process continue......

how to do it ? plz reply

thanks in advace
  Reply With Quote

Old   March 31, 2007, 08:23
Default Re: how to model it
  #2
Mahesh
Guest
 
Posts: n/a
Hi, for the inlet, you can define a velocity function at the inlet boundary conditions and load it when you set the boundary conditions. I havent used it, but details are given inthe userguide. For the outlet, i dont know if there is a direct method to do it. One way is to run the iteration for 2 seconds, use the asme data and feed into a new mesh with wall as boundary conditions. Or i think by using scripting it can be done, but may be a bit involved.
  Reply With Quote

Old   April 2, 2007, 03:58
Default Re: how to model it
  #3
Rohan
Guest
 
Posts: n/a
Hi Renuka,

You need to create a UDF for your transient simulation.

Determine the time you want this process to carry on and you can create a loop and make it run.

Gud luck!!

Regards Rohan
  Reply With Quote

Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
question about turbulence model selection and sensitivity karananand Main CFD Forum 1 February 26, 2010 05:41
Centrifugal Pump and Turbulence Model Michiel CFX 12 January 25, 2010 04:20
Problems bout CFD model of biomass gasification, Downdraft gasifier wanglong FLUENT 2 November 26, 2009 00:27
Reynolds Stress model in CFX vs Fluent Tim CFX 1 October 7, 2009 06:19
Grid resolution for full-scale and down scaled model gravis Main CFD Forum 0 October 2, 2009 10:27


All times are GMT -4. The time now is 16:44.