|April 4, 2007, 10:48||
Gambit error: nonregular side mesh detected
I'm trying to create a mesh on a 3D model constructed from circles and ellipses. I'm including a 3d boundary layer and attempting to mesh via T-grid with a boundary layer cap adjustment.
Each time I do this, however, I get an error which says a non regular side mesh was detected on face x or edge y while constructing 3d boundary layers.
The suggested solution is to not use 3d boundary layers, but those appear much better than standard boundary layers for this model.
What can I change to make this meshing work?
|Thread||Thread Starter||Forum||Replies||Last Post|
|2D Mesh Generation Tutorial for GMSH||aeroslacker||Open Source Meshers: Gmsh, Netgen, CGNS, ...||12||January 19, 2012 03:52|
|Quarter Burner mesh with periosic condition||SamCanuck||FLUENT||2||August 31, 2011 11:34|
|mesh missing after export in gambit||morteza08||Main CFD Forum||0||July 23, 2010 02:19|
|CFX Solver Memory Error||mike||CFX||1||March 19, 2008 08:22|
|3-D Mesh Check in Gambit.....||SHR||FLUENT||4||March 25, 2003 03:10|