 |
 |
 |
|
|
|
[Sponsors] | ||||
April 17, 2007, 07:18
|
Tri vs Quad
|
#1 |
|
Guest
Posts: n/a
|
Hello,
I use Fluent as a solver but I suppose results are the same whatever the solver. Is there a difference between triangle or quadrangle mesh when considering the results and the convergence? Thank you in advance |
|
|
||
|
April 17, 2007, 08:35
|
Re: Tri vs Quad
|
#2 |
|
Guest
Posts: n/a
|
If you have a good mesh quality there should be just one difference and thatīs the calculation time. Because meshing with quads needs 1/3 to 1/4 less cells.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] how can i delect the duplicate mesh line and nodes in interface between quad and tri? | snailstb | ANSYS Meshing & Geometry | 10 | September 26, 2013 08:19 |
| Parallel computing quad core | Prad | Main CFD Forum | 13 | February 9, 2009 14:28 |
| Tri and Quad Mesh | Sham | FLUENT | 1 | December 3, 2007 02:55 |
| Tri vs quad? | eduardo | Main CFD Forum | 0 | April 17, 2007 04:53 |
| Questions about CPU's: quad core, dual core, etc. | Tim | FLUENT | 0 | February 26, 2007 14:02 |
Linear Mode
