|
[Sponsors] |
May 2, 2007, 05:27 |
change boundary conditions
|
#1 |
Guest
Posts: n/a
|
Hello,
I m trying to change an interior boundary condition to a pressure outlet, but it does not appear in the list... Does anyone know another way to do this? Thanks |
|
May 2, 2007, 05:48 |
Re: change boundary conditions
|
#2 |
Guest
Posts: n/a
|
an interior boundary can not be changed to an ouelet.
|
|
May 2, 2007, 07:02 |
Re: change boundary conditions
|
#3 |
Guest
Posts: n/a
|
A pressure outlet needs to be at the outer boundary of the model whereas an 'interior' is by definition somewhere in the interior of the model.
|
|
May 2, 2007, 07:52 |
Re: change boundary conditions
|
#4 |
Guest
Posts: n/a
|
Thank you for your reply,
My problem is that I wanted to make a parametric study concerning the geometry, without iterating from the beginning. I will have to change my strategy... |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Impinging Jet Boundary Conditions | Anindya | Main CFD Forum | 25 | February 27, 2016 12:58 |
non reflective boundary conditions for incompresible flow | Pascal_doran | OpenFOAM Programming & Development | 16 | August 25, 2015 05:35 |
How to change the nature of boundary conditions ? | Bedotto | ANSYS Meshing & Geometry | 3 | August 6, 2010 00:12 |
Concentric tube heat exchanger (Air-Water) | Young | CFX | 5 | October 6, 2008 23:17 |
Fluent accuracy and boundary conditions | Paolo Lampitella | FLUENT | 0 | June 12, 2008 06:25 |