Mass flux - Axisymmetric problems. -- CFD Online Discussion Forums

May 2, 2007, 23:56	Mass flux - Axisymmetric problems.	#1
JSM Guest Posts: n/a	Hi, For axisymmetric problems how to specify the mass flux. In fluent manual, it is specified as mass flux per one radian. But i checked it by mass flow rate surface monitor at inlet, it is not taking correct mass flow rate. How to specify the mass flux for this type of simulations.

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Problems with coedge curves and surfaces	tommymoose	ANSYS Meshing & Geometry	6	December 1, 2020 11:12
mass flow in is not equal to mass flow out	saii	CFX	12	March 19, 2018 05:21
Water subcooled boiling	Attesz	CFX	7	January 5, 2013 03:32
Creating 100 derived parts / Splitting derived parts for mass flux calculation	xamo	STAR-CCM+	8	September 29, 2009 05:35
mass flux units in kg/ms	cfd~	Main CFD Forum	0	May 3, 2007 16:45

All times are GMT -4. The time now is 20:37.