CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   FLUENT (http://www.cfd-online.com/Forums/fluent/)
-   -   How to fix the temperature at the interface in VOF (http://www.cfd-online.com/Forums/fluent/44718-how-fix-temperature-interface-vof.html)

Was May 16, 2007 04:52

How to fix the temperature at the interface in VOF
 
Hi, when I am modelling the VOF, how can I fix the temperature at the interface of the two fluids? or how can I fix temperature throughtout the two fluids? Writing a UDF for volume fraction of 0.5? but how to specify it in fluent?

Any suggestion is appreciated.

Thanks.

elemelek May 21, 2007 13:43

Re: How to fix the temperature at the interface in
 
You should first determine the cells where the 0.5 vol.frac. is located. Then you set the temperature at desired value.


All times are GMT -4. The time now is 23:45.