Home > Forums > Software User Forums > ANSYS > FLUENT

How to fix the temperature at the interface in VOF

Updated Threads

Reply

Search this Thread

May 16, 2007, 04:52	How to fix the temperature at the interface in VOF	#1
Was Guest Posts: n/a	Hi, when I am modelling the VOF, how can I fix the temperature at the interface of the two fluids? or how can I fix temperature throughtout the two fluids? Writing a UDF for volume fraction of 0.5? but how to specify it in fluent? Any suggestion is appreciated. Thanks.

May 21, 2007, 13:43	Re: How to fix the temperature at the interface in	#2
elemelek Guest Posts: n/a	You should first determine the cells where the 0.5 vol.frac. is located. Then you set the temperature at desired value.

Reply

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Adaptative mesh around interface with VOF model	baechtel	FLUENT	0	May 12, 2009 01:35
No results for solid domain	Gary Holland	CFX	10	March 13, 2009 03:30
VOF Lagrangian Interface Tracking	Kam	CFX	3	November 5, 2008 18:08
masse source at the interface in VOF model	Marco	FLUENT	0	September 26, 2007 05:53
Convective Heat Transfer - Heat Exchanger	Mark	CFX	6	November 15, 2004 15:55

All times are GMT -4. The time now is 12:52.