|
[Sponsors] |
February 7, 2012, 01:57 |
shock tube setup
|
#1 |
New Member
Aditya
Join Date: Dec 2011
Posts: 28
Rep Power: 14 |
Hi,
I am tryin to simulate a M=2.1 shock wave in FLUENT. I have defined a UDF for the boundary conditions and using a courant number of 1. Immediately after the calculation starts the values deviate a lot frm the set values and the calculation from there on goes haywire. Can someone tell me why this is happening and wat are the things i need to look into for rectifying the problem Thanks!!! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
HLL Riemann Shock Tube Matlab Problem | Luke F | Main CFD Forum | 2 | May 20, 2016 02:10 |
Shock tube simulation | harish | FLUENT | 5 | January 25, 2014 02:20 |
rhoCentralFoam not reflecting shock in Shock Tube? | Astaria | OpenFOAM Running, Solving & CFD | 5 | March 4, 2012 03:07 |
shock tube validation | AB | Main CFD Forum | 3 | December 10, 2004 07:31 |
Shock tube problem | AB | Siemens | 1 | November 9, 2004 00:25 |