|
[Sponsors] |
June 4, 2007, 13:08 |
grid adaptation
|
#1 |
Guest
Posts: n/a
|
Hello,
I want to adapt a mesh in order to satisfy the Yplus requirement close to a wall with a hexaedral boundary layer mesh. I can mark the cells that need to be adapted but the adaption does not occur. The number of a changed cells is zero. Any suggestions? Thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
No grid adaptation | Pimmie80 | FLUENT | 1 | September 21, 2010 08:35 |
grid partition AND dynamic mesh adaptation !!!!!!! | bohis | FLUENT | 0 | January 16, 2009 03:00 |
Grid Adaptation | Suresh | FLUENT | 0 | October 15, 2003 13:18 |
Combustion Convergence problems | Art Stretton | Phoenics | 5 | April 2, 2002 05:59 |
floating point error during grid adaptation | Nurul Murad | FLUENT | 2 | September 5, 2001 19:15 |