CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   FLUENT (http://www.cfd-online.com/Forums/fluent/)
-   -   Display surface (http://www.cfd-online.com/Forums/fluent/45008-display-surface.html)

cotket June 12, 2007 11:36

Display surface
 
Hi all i am new to this forum, i am using Fluent to simulate a 3D model. The model consist of two tube in parallel. I want to display only a surface of one tube,i don't know how to display a cross-section of each tube. Can anyone help me to do this. Thanks

amir June 12, 2007 14:07

Re: Display surface
 
hi you mean that u dont want see both of them in same window?


cotket June 13, 2007 03:51

Re: Display surface
 
Thanks for your response, i want to see tube separately. Because i need to calculate wall shear stress at each cross section. If both of them display in the same window, the value becomes average. Thanks again


All times are GMT -4. The time now is 04:13.