|
[Sponsors] |
June 14, 2007, 23:17 |
importing c-grid into Gambit
|
#1 |
Guest
Posts: n/a
|
Hi, I have an airfoil grid. Its a c-grid. I created a neutral file and imported it into Gambit. After some modifications, when I export the mesh for fluent, I cannot seem to get rid of the inner edge of the c-grid which basically forms the airfoil and the wake. I would appreciate if anybody could suggest ways to export this c-grid so that the wake center edge would not be exported as a wall.
Thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Does Gambit has a maximum allowable grid number? | spartan1516 | ANSYS Meshing & Geometry | 7 | March 25, 2010 09:08 |
Problems importing written gambit .neu mesh file | jemteo | FLUENT | 3 | February 20, 2006 01:42 |
Importing Patran mesh into Gambit | Trac | FLUENT | 1 | September 29, 2005 10:32 |
Problem importing GAMBIT mesh to Ansys geometry | David G. | CFX | 0 | June 19, 2005 06:01 |
Grid for Fluent v.4 using Gambit? | Ray | Main CFD Forum | 3 | October 27, 1999 12:35 |